Wedge-cap pedestal

Wedge-cap is a fully adjustable pedestal  using a set of interlocking components. It is ideal for raising and levelling floors and decking.

Common to all pedestals is the Capital. This provides the interface between base and cap
wedge and spreads the point load over a wider area enhancing stability.

The capital may be elevated by attaching Column Blocks. These extensions feature 
locking tags in each corner which locate with matching recesses in the base of the 
capital. Each Column Block provides a 35mm height extension.

There are three interchangeable colour coded Cap Wedges for fine height adjustment in
0.5mm increments (Hi-Cap, Mid-Cap and Lo-Cap Wedges). Cap wedges feature the familiar
tooth like grips which prevent slipage during adjustment and also a central locating
rail to ensure accurate alignment. Timbers may be nailed or screwed through the Cap
Wedge into the Capital for a permanent fix.

Dimensions in mm

For roof deck applications the pedestal can be embedded in epoxy based adhesive
without adverse chemical reaction. Components are water resistant and dimensionally
stable permitting excellent drainage below floor level.

Height range: 32mm to 250mm

* Coarse adjustment with interlocking column blocks of 35mm each.

* Fine adjustment of 0.5mm using one of three interchangable cap wedges

 Load Bearing: 200kg point load with maximum compression of 2.5mm 

A minimum of 5 pedestals per square metre is recommended and lateral movement of the
whole floor should be restrained.

Manufactured under ISO 9001 certified procedures.

Copyright 2006-2007 Stadon Level Limited